Milestone M50 Manual do Utilizador descarregar pdf (Página 77)

Milestone Husky M30/M50

Administrator's Manual

www.milestonesys.com

Advanced configuration

Dual stream:

This feature is only available on cameras supporting dual stream.

Name

Description

Enable dedicated live stream

This additional stream feature lets you use the alternative stream of

the camera. It enables two independent streams to the recording

server—a stream for live viewing and another stream for recording

purposes, with different resolution, encoding, and frame rate.

Stream

Select the type of the live stream. Stream settings for viewing live

video and for recording video may very well be different in order to

get the best result.

Resolution

Select the resolution of the camera.

FPS

Select the camera's live frame rate per second (FPS)

If the camera uses the MPEG video format

With MPEG, you can define frame rate and other settings:

Name

Description

Frame rate per second

Frame rate for viewing live and recorded video from the camera.

Select number of frames per second.

Record keyframes only

Keyframes stored at specified intervals record the entire view of the

camera, whereas the following frames record only pixels that

change. This helps greatly reducing the size of MPEG files. Select

the check box if you only want to record keyframes. Note that you

can specify exceptions if motion is detected or events occur.

Record all frames on motion

Allows you to make exceptions if you have selected to record

keyframes only. Select this check box to record all frames when

motion is detected. Two seconds after the last motion is detected,

the camera will return to recording keyframes only.

Record all frames on event

Allows you to make exceptions if you have selected to record

keyframes only. Select this check box to record all frames when an

event occurs and until another event occurs. Use of this feature

requires that events have been defined, and that you select start

and stop events in the neighboring lists.

Tip: If you have not yet defined any suitable events, you can quickly

do it: use the Configure events list, located below the other fields.

Start Event

Use when recording on Event or Motion Detection & Event.

Select required start event. The camera will begin recording all

frames when the start event occurs.

Stop Event

Select required stop event. The camera will again only recording

keyframes when the stop event occurs.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 214 215

Comentários a estes Manuais

Sem comentários

Milestone M50 Manual do Utilizador Página 77

Comentários a estes Manuais

Manuais e produtos relacionados com Software Milestone M50